Set-up
Before learning how to put a needle in a Janome Sewing Machine, it is important to familiarize oneself with the basic parts of the machine and its operation. To accomplish this, read the Janome instruction manual and discover the different parts of the machine and their names. Once the parts have been identified and the workings of the machine understood, it will be easier to understand the rest of this tutorial.
Put the Needle in the Machine
Now that the components and their associated functions have been identified, it is time to put the needle in the machine. To do this, start by releasing the needle clamp screw. This will allow the needle to be removed. Put the new needle into the needle clamp and ensure that the flat side of the needle is facing toward the back of the machine. Tighten the needle clamp screw until it is snug but not too tight.
Threading the Janome Sewing Machine
After the needle has been placed into the needle clamp, it is time to thread the machine. Begin by winding the thread onto the spool pin. Pass the thread through the first thread guide and then thread the upper looper. Pass the thread through the needle eye, and around the tension discs. Lastly, thread the lower looper.
Adjusting the Sewing Machine Needle
Now that the machine has been threaded, it is time to adjust the needle. To do this, turn the hand wheel to raise the needle to its highest position. Make sure that the needle clamp screw is facing the right direction and that the required strain is applied to the needle. If all is correct, the needle should penetrate the cotton cloth easily.
Cleaning the Janome Sewing Machine
It is important to periodically clean the Janome Sewing Machine. To do this, start by unplugging the machine from the power source and removing the needle from the needle clamp. Use a lint-free cloth to clean the body of the machine, the needle clamp, and the needle. Avoid using water or harsh chemicals.
Testing the Janome Sewing Machine
After all of the components have been placed, the machine has been threaded, and the needle has been adjusted, it is time to test the machine. Start by inserting a piece of cotton cloth in the machine and turning the hand wheel to assist in lowering the needle. If the tension is correct, the needle should penetrate the cotton cloth easily and the stitches should be even and consistent.
Conclusion
The Janome Sewing Machine is a great tool for solving small sewing and fabric repairs. By learning the different parts of the machine, the names of the components, and understanding how to put the needle in the machine, thread the machine, adjust the needle, and clean the machine, a user can become skilled in making repairs and completing projects.
Changing Bobbin
When the stitches reach the end of the fabric, the user must remove the bobbin from the machine. To do this, turn the hand wheel to the highest position and open the top cover. Pull the bobbin out of the machine and unwind the old thread. Put a new bobbin into the machine, ensuring that the thread goes in the correct direction. Wind the bobbin with the new thread and close the top cover.
Changing Stitch Length
The stitch length of the Janome Sewing Machine can be adjusted to provide a better fit for the project. To do this, locate the stitch length dial on the machine and make sure the needle is in its highest position. Turn the dial to the desired stitch length. It is important to remember that the smaller the number, the shorter the stitch is.
Changing Stitch Width
Some Janome Sewing Machines have the ability to adjust the stitch width. To do this, locate the stitch width dial on the machine and make sure the needle is in its highest position. Turn the dial to the desired stitch width. It is important to remember that the smaller the number, the narrower the stitch will be.
Troubleshooting Common Issues
When sewing with a Janome Sewing Machine, it is important to be aware of some common issues that can occur. Most problems can be solved by ensuring that the machine is threaded correctly, that the needle is inserted properly, and that the bobbin is in the correct position. If all else fails, consult the Janome instruction manual or the local Janome dealer for assistance.
